The following changing table is brought to you by...

Well the changing table is taking form and I am ready to start sanding and finishing. Besides a few wrong cuts and nailed pieces (apparently the 1/4 sheet of plywood for the back of the table, goes on the inside of the frame, oops) the building went well and was fun. Here are a few pictures of the final rough assembly.

Below is a picture of the major tools used in this project. It's no Norm Abrams shop, but they did the job well.

The following tools were used for this project:

- Irwin clamps and levels, Jet 10" table saw, Craftsman 10" compound miter saw, Porter Cable compressor and brad nailer, Bosch router, Bosch router table, Kreg pocket hole jig, Makita 18v drill, Bosch 10.8v driver, B&D jig saw, Hitachi circular saw, & keeping it all clean ..the Shopvac.